Geared motor JM.3ESA TURBO

Fast 24 Vdc gear motor for intensive use with integrated control unit and encoder
JM.3ESA TURBO | Automations for garage & industrial doors | Automatismi Benincà
Download the instruction manual

Residential use

Commercial use

Sectional garage doors

24 Vdc

Up to 11 ㎡

Gear motor with opening speed higher than standard values

Integrated device that guarantees maximum precision during the automation manoeuvring steps

Intelligent power control system that allows obtaining dynamic data through a precise calculation of the thrust. The system is able to locate any critical points and adjust the torque accordingly in relation to actual requirements and according to measured performance

64 transmitters storable inside the receiver


24 Vdc | intensive use

Fast 24 Vdc gear motor for intensive use with integrated control unit and encoder | The encoder guarantees maximum safety and precision while the gate is moving | STC system device enables torque management in relation to the position of the gate, which guarantees maximum safety | Maximum performance and speed (15.5 m/min) | Opening speed can be set independently from the closing speed | Integrated energy saving LED courtesy light | Operation guaranteed even in the event of a power supply failure through batteries that integrate perfectly into the motor | Anti-crushing system with amperometric obstacle detection | Stroke is adjustable with 2 mechanical stops provided | Quick hooking system for connecting the arm to the door plate

Rail not included

Power supply 230 Vac (50-60Hz)
Motor supply 24 Vdc
Max absorbed current 0.7 A
Thrust 600 N
Opening speed 8,9 ÷ 15,5 m/min
Duty cycle intensive use
Protection level IP40
Built-in control unit
Integrated receiver
Limit switch electronic with encoder
Operating temperature -20°C /+50°C
Door surface area 11 ㎡/max
Weight 5.8 kg
N. motors per pallet 50



1 actuator series JM.3ESA TURBO


230 Vac - 50/60 Hz


24 Vdc / 8.5 A


Integrated LCD display | Integrated 433.92 MHz 64-code radio receiver with 3 encoding systems (Advanced Rolling Code, Rolling Code, Fixed Code) | Integrated ESA SYSTEM for energy savings | Fixed terminal boards | Automatic and semi-automatic logic | Step by step, open, close, stop and photocell inputs | Input for N.C or 8K2 sensitive edge | Output for configuration as gate open indicator, service light, second radio channel or area light | Output for connecting the flashing light | Photocell testing | Autosetting of operating parameters | Electronic torque adjustment with automatic calculation for each point in the stroke (STC SYSTEM) | Anti-crushing safety thanks to amperometric detection and encoder management | Possibility of setting a slower starting speed for 2 seconds (SOFT START) | Adjustable slow-downs | Advantouch system to configure parameters and manage radio transmitters | Number of maneuvers | Programming access password | Maintenance warning

Technical Drawing JM.3ESA TURBO
Terminal Diagram JM.3ESA TURBO