CP.J3-SW

CP.J3-SW
CP.J3-SW | Internal control units | Automatismi Benincà
Download the instruction manual

Control unit that manages the encoder for maximum precision during the automation manoeuvring steps

Intelligent power control system that allows obtaining dynamic data through a precise calculation of the thrust. The system is able to locate any critical points and adjust the torque accordingly in relation to actual requirements and according to measured performance

433.92 MHz Receiver equipped exclusively with Advanced Rolling Code (ARC)

This function automatically adjusts the operational parameters for simplifying the system’s installation and testing operations

This is a protocol for connection with KNX home automation systems by connection of the X.BE card (optional)

Predisposition to manage the control unit using the BeUP app and pro.UP accessory which, by recreating the control unit menu, makes it possible to adjust parameters and logic, read error messages and update the firmware. It is possible to perform remote diagnostics, check the status of the gate and send commands.

64 transmitters storable inside the receiver

Identifies motors or control units with power consumption in standby mode of ≤ 0,8 W.

CP.J3-SW

APPLICATION

1 operator for JM.3 sectional garage doors

CONTROL UNIT POWER SUPPLY

230 Vac - 50/60 Hz

MOTORS POWER SUPPLY

24 Vdc / 8 A

POWER CONSUMPTION IN STAND-BY

0.8 W

MAIN FUNCTIONS

Regulation of operating parameters and logics through trimmers, dip-switches and buttons | Integrated 433.92 MHz 64-code radio receiver with ARC coding | Fixed terminal boards | Automatic, semi-automatic and Deadman logic | Step by step, stop and photocell inputs | Integrated LED courtesy light | Output for connecting the flashing light | Autoset of operating parameters | Electronic torque adjustment with automatic calculation for each point of the stroke (STC SYSTEM) | Separate electronic adjustments of opening and closing speeds | Anti-crushing safety through amperometric detection and encoder management | Electronic regulation on 4 levels of residual tension of the belt at the end of the manoeuvre | Adjustable slow-downs | Built-in energy saving system ESA+ | Advantouch system to configure parameters and manage radio transmitters | Set up for connection to SW.CB battery charger (optional) | Set up for connection to KNX systems via X.BE card (optional) | Use of the pro.UP accessory and the BeUP app makes it possible to access an advanced programming level, to consult the number of manoeuvres and to protect the control unit with the password, in addition to making the diagnostics and firmware update functions available

Technical Drawing CP.J3-SW
Terminal Diagram CP.J3-SW