CP.W24-5IN
24 Vdc
Encoder signal recreated by the control unit beginning with the measurements of electric motor operation parameters. It is possible to manage slowing optimally and trace gate travel while providing the torque data in relation to its position to guarantee maximum safety
Intelligent power control system that allows obtaining dynamic data through a precise calculation of the thrust. The system is able to locate any critical points and adjust the torque accordingly in relation to actual requirements and according to measured performance
433.92 MHz Receiver equipped exclusively with Advanced Rolling Code (ARC)
This function automatically adjusts the operational parameters for simplifying the system’s installation and testing operations
This is used to set the number of cycles after which the required maintenance of the system is signaled
This allows a code to be entered for protection of the control unit programming, to prevent access to menus and modification of parameters
Prepared for the connection of X.BE (KNX) and Q.BE (MQTT) accessories
Designed to manage the control unit using the BeUP app and pro.UP accessory which, by recreating the control unit menu, makes it possible to adjust parameters and logic, read error messages and update the firmware. It is possible to perform remote diagnostics, check the status of the gate and send commands
64 transmitters storable inside the receiver
Standby power consumption complies with European regulation (EU) 2023/826
CP.W24-5IN
APPLICATION
1 actuator for sliding door series WOLF624
CONTROL UNIT POWER SUPPLY
115 or 230 Vac (selectable) 50/60Hz
MOTORS POWER SUPPLY
24 Vdc / 9 A
MAIN FUNCTIONS
Integrated LCD display | Integrated radio receiver 433.92 MHz 64 codes with ARC coding | Removable terminal boards | Automatic, semi-automatic and Deadman logic | 5 Multifunction inputs ensure multiple configuration possibilities for each wired input, for example: step-by-step, open, close, stop, pedestrian, active photocell in opening, active photocell in closing, N.C. sensitive edge | Configurable outputs for gate open warning light, second radio channel, courtesy light, zone light, accessory test output, flashing output, gate open alarm, NC input alarm | Output for flashing light connection configurable as steady or flashing light | Autoset of operating parameters | Electronic torque adjustment with automatic calculation for each point in the stroke (STC SYSTEM) | Separate electronic adjustments of opening and closing speeds | Anti-crushing safety through amperometric detection | Virtual encoder | Adjustable slow-downs | Built-in energy saving system ESA+ | Designed for connection of X.BE (KNX) and Q.BE (MQTT) accessories | Configuration, diagnostics, firmware update, and remote control management via the BeUP app, using the PRO.UP accessory | Number of manoeuvres | Programming access password | Maintenance warning | Set up for connection to SW.CB battery charger (optional) | Standby power consumption complies with European Regulation (EU) 2023/826
